Telular SX6P-200C 用户手册
3.
Install the screws (not supplied) into the wall, leaving a gap of approximately 3 mm (1/8 inches)
between the screw head and the wall.
between the screw head and the wall.
4.
Align the mounting holes with the screws and mount the SX6P onto the screws -
see Figures 10
and 11
.
Connecting the SX6P to AC Power
1.
Connect the DIN connector of the AC power cord into the AC power input on the rear panel of
the SX6P -
the SX6P -
see Figure 12
.
2.
Plug the AC power cord into the wall socket.
3.
Check the cellular signal strength and move the unit until the best signal possible is
achieved - see the
achieved - see the
Service Indication
section of this manual on page 7.
AC Power Cord
Wall Socket
AC Power
Input
DIN
Connector
Figure 12 – SX6P AC power connection.
Figure 11 – Mount the SX6P onto the screws.
83 mm (3-1/4 inches)
Figure 10 – SX6P mounting hooks.
Mounting
Holes
Phonecell
®
SX6P CDMA
4
User Manual