Adtran 612 用户手册
Total Access 600 Series System Manual
Section 4 User Interface Guide
61200624L1-1B
© 2004 ADTRAN, Inc.
115
L2 P
ROTOCOL
(ATM F
IRMWARE
) – DSX I
NTERFACE
Configure the
L2 P
ROTOCOL
parameters and view the status of the integrated DSX interface using items
from this menu.
L2 P
ROTOCOL
(ATM – DSX) > C
ONFIG
Configures the voice parameters for the interface.
I
NTERFACES
(ATM – DSX) > C
ONFIG
> S
IGNALING
Configures the voice signaling implemented on the interface. The signaling must match the network
application. The choices are:
application. The choices are:
I
NTERFACES
(ATM – DSX) > C
ONFIG
> T
X
OAM
Configures the Total Access 600 Series to transmit an Operation, Administration, and Maintenance
(OAM) cell to the network (voice gateway) when the DSX interface is down.
(OAM) cell to the network (voice gateway) when the DSX interface is down.
I
NTERFACES
(ATM – DSX) > C
ONFIG
> R
X
OAM
Configures the Total Access 600 Series to transmit an alarm condition to the DSX interface when the
network (voice gateway) is down.
network (voice gateway) is down.
I
NTERFACES
(ATM – DSX) > C
ONFIG
> L
EGACY
C
ONFIG
Digital trunk channel ID's are bits used to identify voice calls being carried within ATM cells. Some
gateways do not support higher channel IDs, therefore the Total Access 600 Series supports CIDs from 16
or 65. The default is
gateways do not support higher channel IDs, therefore the Total Access 600 Series supports CIDs from 16
or 65. The default is
DSX CID
FROM
65
.
The DSX-1 Interface is optional and only available on 3rd Generation units.
E&M (T
ANDEM
)
Sets the DSX interface to use E&M signaling.
L
OOP
S
TART
Sets the DSX interface to use loop start signaling.
G
ROUND
S
TART
Sets the DSX interface to use ground start signaling.
ISDN PRI
Sets the DSX interface to use common channel signaling for ISDN.