I.R.I.S. 200 用户手册
Iris Touch 200 Range Dialer Installation Manual
8
6. Post
installation
Once you have completed the installation you must:
•
Ensure the system is running correctly, the LED light on top of the unit
is on steady and alarms are being signaled to the Monitoring Centre
correctly.
is on steady and alarms are being signaled to the Monitoring Centre
correctly.
•
After a short period of inactivity the display will switch off. To switch it
back on, touch the display anywhere.
back on, touch the display anywhere.
•
If a fault should develop, then the LED light
on the top of the unit will
start flashing and the display will show a system fault message. This
message can be touched to gain access to more information. Ensure
the user is aware of this and what action they need to take should a
fault occur.
message can be touched to gain access to more information. Ensure
the user is aware of this and what action they need to take should a
fault occur.
7. PIN
alarms
The IRIS Touch series have PIN inputs
[18]
that can be used to generate alarm
messages. These can be:
•
Text messages via SMS (GSM / Ethernet & GPRS only).
•
SIA alarm messages over IP to the Monitoring Centre (Ethernet /
Ethernet & GPRS only).
Ethernet & GPRS only).
•
Fast Format alarm messages over IP to the Monitoring Centre
(Ethernet / Ethernet & GPRS only).
(Ethernet / Ethernet & GPRS only).
The messages for each PIN can be configured via the Settings Menu on the
touch screen display. See Appendix A for more details.
touch screen display. See Appendix A for more details.