Nortel Networks 1000E 用户手册
Page 200 of 488
Configuring the CS 1000E Call Server
553-3041-210 Standard 4.00 September 2007
Introduction
The CS 1000E system requires the configuration of an IP telephony node.
The configuration data is stored in the BOOTP.TAB and CONFIG.INI files
on the CS 1000E. Copies of both files are maintained on each node
component (Signaling Server and Media Card).
The configuration data is stored in the BOOTP.TAB and CONFIG.INI files
on the CS 1000E. Copies of both files are maintained on each node
component (Signaling Server and Media Card).
The preconfigured IP telephony configuration files from the leader Signaling
Server must be imported. These files are saved on the CS 1000E as:
Server must be imported. These files are saved on the CS 1000E as:
•
c:/u/db/node/nodex.cfg where x is the node number
•
c:/u/db/node/nodex.btp where x is the node number
The node database files are backed up along with the customer database using
the LD 43 EDD command.
the LD 43 EDD command.
This chapter contains the following procedures:
•
•
•
•
•
•
•
•
•
IMPORTANT!
Do not attempt to alter the configuration files either manually or with
OTM’s ITG or IP Phone management. Use Element Manager only.
OTM’s ITG or IP Phone management. Use Element Manager only.