Mitsubishi Electronics 837 SERIES 用户手册
5. NetCommand IR Control (837 Series)
47
To perform this procedure, you need:
The remote controls for both the TV and the
•
device you want to control.
An IR emitter cable available from Mitsubishi
An IR emitter cable available from Mitsubishi
•
.
Note: To set up an A/V receiver, see “Setting Up A/V
Receiver Control,” page 52.
Connect and position the IR emitters for the
1.
devices you wish to control. See “IR Emitter Place-
ment” on the opposite page.
Set the
ment” on the opposite page.
Set the
2.
TV’s remote control to TV mode and power
on the TV.
Open the NetCommand
Open the NetCommand
3.
Learn screen as follows:
If working from the
•
New Device Found screen
after the device is first detected, highlight
NetCommand and press ENTER to open the
Learn screen for the device.
If performing NetCommand setup at any time
NetCommand and press ENTER to open the
Learn screen for the device.
If performing NetCommand setup at any time
•
after the device has been recognized through
Auto Input Sensing:
a. Press ACTIVITY.
b. Highlight the desired input icon and press
Auto Input Sensing:
a. Press ACTIVITY.
b. Highlight the desired input icon and press
ENTER to switch to that input.
c. Press MENU, highlight Inputs, and highlight
Learn to open the Inputs > Learn screen
for the device.
for the device.
The first function highlighted in the
4.
Learn screen
is always
Power On. Aim the TV’s remote control
at the TV and press
ENTER to begin learning for that
function.
When the
When the
5.
Power On text starts flashing, aim the
device’s remote control at the TV and hold the POWER
key until a check mark appears next to
key until a check mark appears next to
Power On.
If the text stops flashing before the check mark
•
appears, repeat the previous step.
To remove the key from NetCommand control,
To remove the key from NetCommand control,
•
press the
CANCEL key while the key name is
highlighted.
Press the
6.
keys on the
TV’s remote control
to highlight other keys on the list. Repeat steps
4 and 5 for each additional function you wish to
control through NetCommand.
4 and 5 for each additional function you wish to
control through NetCommand.
Note: Device keys in the far right column will be asso-
ciated with the remote control’s
MORE key when
“learned.” See the table on page 49.
If the device has a separate
7.
POWER OFF key, press
on the
TV’s remote to highlight Power Off.
Repeat the earlier steps to “learn” the
POWER OFF key.
If the device has no POWER OFF key, skip this step.
Press
Press
8.
BACK to finish NetCommand “learning” for the
current device.
From the New Device Found screen, highlight
NetCommand and press ENTER to open the Learn
screen.
NetCommand and press ENTER to open the Learn
screen.
Initial NetCommand Setup
Inputs > Learn screen
Key names marked with a
check have been “learned.”
check have been “learned.”
Device-specific keys in the
rightmost column can be accessed
with the MORE key after “learning.”
with the MORE key after “learning.”
Adding or Removing Device Keys from
NetCommand Control
NetCommand Control
Switch the TV to the device. Press
1.
ACTIVITY, high-
light the device’s icon, and press
ENTER.
Open the
2.
Inputs menu and highlight the Learn icon.
When the
3.
Learn screen displays:
To add keys:
•
Continue as described earlier
under “Initial NetCommand Setup” on this
page.
To delete keys:
page.
To delete keys:
•
Highlight the name of the key
you wish to delete and press
CANCEL on the
TV‘s remote control to clear the check mark.