Sharp PGLW2000 用户手册

52

Using 3D Viewing Mode

Use the following procedure to project 
3D images. 

For operation of the 3D LCD shutter 
glasses and the 3D-video playback 
equipment, see the corresponding 
operation manual.

O/Q buttons 

ENTER button 

3D MODE button 

Projecting 3D images

1

  Turn the projector on.

2

  Turn the 3D-video playback 

equipment on.

 Set the 3D-video playback equipment so 
that it outputs one of the signals listed in 
the Compatibility Chart in this operation 
manual.

3

  Switch the Input mode of the 

projector to enable input of 3D 
video signals.

4

  Operate the 3D-video playback 

equipment and play back the 3D 
content.

5

  Turn the 3D LCD shutter glasses 

on and place them over your eyes.

•

1

2

3

4

5

6

 Press 

3D MODE on the remote 

control to display the 3D MODE 
menu.

Info

If “An invalid button has been pressed.”
is displayed, a 3D-compatible signal is 
not being input. Check the output signal 
on the playback equipment.

•

7

 Press 

Q to set “DLP

®

 Link™” to 

“On”.

8

 Press 

ENTER to switch the mode 

and enable more natural 3D 
image viewing.

Warning!

If the projector, 3D-video playback 
equipment, and 3D LCD shutter 
glasses are not properly set, you may 
experience eye strain in addition to not 
being able to view the images in 3D.

•

9

 Press 

3D MODE.

 The 3D MODE menu will disappear.

If the images are not displayed in 3D, repeat 
steps 6 to 8.
You can also use “DLP

®

 Link™” and “DLP

® 

Link™ Invert” on the menu screen to change 
the 3D setting.

•

•

Note

Ending 3D projection

1

 Press 

3D MODE on the remote 

control to display the 3D MODE 
menu.

2

 Press 

O to set “DLP

®

 Link™” to 

“Off”.

3

 Press 

3D MODE.

The 3D MODE menu will disappear.

•

•

6

 

7

 

8

 

9

 

1

 

2

 

3

 

Viewing Stereoscopic 3D Images (Continued)