Clarity WN=5230-S 用户手册

 

 

WN-5230-S VideoWall User’s Guide 

 

 

27 

picture will look.  

F.  If the two measurements are the same, you have 

a rectangle with perfectly square corners, 

and you may go on to Step 4.  

G.  If the two measurements are not the same, within 

1/32

nd

  inch (0.8 mm), the frame is not a rectangle 

with perfectly square corners, it is a 

parallelogram. 

Loosen the top Locking 

Screws on each side. Move the adapter plate left 
or right a bit and tighten the screws. Measure the 
diagonals again. Repeat this process until you are 
satisfied that the two diagonals are the same. 
This means the adapter plate is a perfect 
rectangle with square corners. 

A.  Now that the center unit adapter plate is squared, 

align one of its neighbors in the bottom row. 

B.  The diagram above shows the order in which you 

should align the displays in a typical video wall. 
(Note:  This is not the same as the Unit ID 
address of the display units.)   

C.  The Alignment Tool fits over the seam of two 

adjacent adapter plates. The Tool has six guide 
pins, three on each side, and four spring-loaded 
screws, two on each side. (Only two of the spring-
loaded screws, one on each side, will be used at 
a time.)   

D.  Position the Alignment Tool between the two 

displays. One of these (#1) is already square and 
the other (#2) is about to be aligned. Fit the tool 
into display #1 first and attach it with the lower 
spring-loaded screw. The guide pins should go 
into the Alignment Holes in display #1.    

E.  Loosen the two Locking Screws in #2 on its right 

side under the Alignment Tool and move the 
adapter plate of display #2 until the guide pins go 
in the Alignment Holes. Secure the Alignment 
Tool to #2 with the spring-loaded screw. Tighten 
the two Locking Screws on #2 under the 
Alignment Tool. (Do not be concerned about the