Clarity WN=5230-S 用户手册

Clarity Visual Systems 

   September 1999 

68 

Using your thumb and middle finger to unlock the lamp cable 
connector, use your index finger to pull the connector away from 
the lamp. 

The lamp cable will remain connected to the optical engine. 

Push the lamp to the right (into the optical engine) while turning 
counterclockwise. The lamp will rotate about an eighth of a turn, 
and then it can be pulled to the left (out) and removed. 

Reinsert a UHP 100W lamp in the same orientation. Push the 
lamp in and rotate the lamp clockwise until it locks into place. 

When attaching the lamp cable, pinch the connector clamp 
together while inserting the connector. The connector is keyed 
so it will only go on one way. 

Replace the lamp access door on the optical engine. 

Close and latch the projector compartment hood.

 

Reinstall the screen by lining up the latches and pressing the 
screen inward. It will go in with a distinct “pop.”  Give it a slight 
pull to see that it is securely in place.  

 

On both sides of the screen, near the top and bottom, the 
mullion is slightly lifted from the screen material, forming a 
little bump. The removal tool fits here. 

The small hook on the removal tool slips under the bump in 
the mullion. The other side of the tool should press against the 
mullion of the neighboring screen. Use care when using the 
tool so it doesn’t scratch the screen material. 

Squeezing the handle of the removal tool pulls one screen out 
far enough to let it “pop” out at that corner. The tool uses the 
neighboring screen for leverage.  

Remove the screen carefully and set it aside.