HP (Hewlett-Packard) 0706124 REV B 用户手册
Menu
2-13
after manually winding back a service loop. The default is
Novice mode.
Novice mode.
When in Expert mode, active Warnings, Changes, and
Actions can be displayed by selecting Warnings & Actions
from the menu, since Warnings will not cause the ATTN icon
will appear in Expert mode. See “User Assistance” on page 2-
3 for further information about Actions and Warnings. See
“Warnings & Actions” on page 2-21 for further information
about this menu option.
Actions can be displayed by selecting Warnings & Actions
from the menu, since Warnings will not cause the ATTN icon
will appear in Expert mode. See “User Assistance” on page 2-
3 for further information about Actions and Warnings. See
“Warnings & Actions” on page 2-21 for further information
about this menu option.
◆ Audible Alarm — when enabled and one or more Actions are
pending, sounds a beep until the AT TN key is pressed.
◆ Service Station Spits — adjusts the number of times ink is
expelled (“spit”) during a single service station visit. The set-
tings are 1 through 10. To reduce the number of missing or
misfiring jets, increase this setting.
tings are 1 through 10. To reduce the number of missing or
misfiring jets, increase this setting.
◆ SS Overspray Delay — when enabled, this setting will pause
the printhead carriage in the service station area briefly
(approximately one second) before exiting, to eliminate fine
overspray on the right side of prints (nearest the service sta-
tion).
(approximately one second) before exiting, to eliminate fine
overspray on the right side of prints (nearest the service sta-
tion).
Printer Options
◆ Dryer — turns the dryer fans on or off. Disable the dryer fan
to avoid streaking output on poly media and films.
◆ Print White Space — when enabled (on), the printhead car-
riage always travels the width of the media, even when there
is a white (blank) space in the image. When disabled (off),
the printhead remains in its home position and the media
advances past white spaces in the image.
is a white (blank) space in the image. When disabled (off),
the printhead remains in its home position and the media
advances past white spaces in the image.
◆ Quality Check — when enabled, the printer determines the
number of misfiring or not firing ink jets that are not being
replaced by other jets. If this number exceeds a maximum
value, an error occurs. This can give the operator a chance to
print anyway, or cancel printing so the problem can be
resolved.
replaced by other jets. If this number exceeds a maximum
value, an error occurs. This can give the operator a chance to
print anyway, or cancel printing so the problem can be
resolved.
◆ Attended Mode — user must press B (Proceed) to
acknowledge the error and print the job (if one is pend-
ing), or
ing), or
y (Cancel) to cancel printing.
◆ Unattended Mode — no user acknowledgment of errors
is required. When a quality check fails, print jobs are sent
to the ColorSpan print server’s Attention queue with a
disposition of “Uncalibrated Printer” (this feature may
not be supported on non-ColorSpan print servers).
to the ColorSpan print server’s Attention queue with a
disposition of “Uncalibrated Printer” (this feature may
not be supported on non-ColorSpan print servers).