Raritan Computer 255-30-6000-00 用户手册
Installing a Serial CIM
190
To set up a “local user station,” plug a PS/2 keyboard into AUATCʹs
6‐pin mini‐DIN connector, or a Sun keyboard into its 8‐pin mini‐DIN
connector. Then plug a VGA monitor into AUATCʹs HD15 connector.
6‐pin mini‐DIN connector, or a Sun keyboard into its 8‐pin mini‐DIN
connector. Then plug a VGA monitor into AUATCʹs HD15 connector.
Note: This local station will contend for keyboard control with the
remote user stations attached to Paragon user stations based on a
fixed one‐second activity timeout. As soon as there has been no
keyboard activity from the local station for one second, a remote
station can take keyboard control, and vice versa.
remote user stations attached to Paragon user stations based on a
fixed one‐second activity timeout. As soon as there has been no
keyboard activity from the local station for one second, a remote
station can take keyboard control, and vice versa.
3. Plug in and turn on the device. If possible, set it to communicate at
9600 bps, 8 data bits, no parity, and 1 stop bit. (These donʹt have to be
the permanent serial settings, but the device must be set this way to
establish initial communication with AUATC; later you can configure
both the device and AUATC to better settings. If the device canʹt be
configured for these settings, youʹll need to temporarily attach a
server or other device that can be.)
the permanent serial settings, but the device must be set this way to
establish initial communication with AUATC; later you can configure
both the device and AUATC to better settings. If the device canʹt be
configured for these settings, youʹll need to temporarily attach a
server or other device that can be.)
4. Plug AUATCʹs power supply into AUATC and a working AC outlet.
If AUATC is installed and operating properly, AUATCʹs green LED
will start blinking: once per second while the CIM is idle, more
quickly while itʹs passing data in either direction.
will start blinking: once per second while the CIM is idle, more
quickly while itʹs passing data in either direction.
5. Connect one end of a Cat 5 UTP cable to the RJ45 port on AUATC.
Connect the other end of the cable to RJ45 channel port #1 on the back
of one of your Paragon Base Units, or to the RJ45 port on the back of a
user station if you want Direct Mode access (see User Station Direct
Mode (on page 178) for additional information).
of one of your Paragon Base Units, or to the RJ45 port on the back of a
user station if you want Direct Mode access (see User Station Direct
Mode (on page 178) for additional information).