Raritan Computer 255-30-6000-00 用户手册
Chapter 2: Installation
19
Test Chan. UKVM (CIM UKVM):
Used by an administrator to check if a CIM is functioning properly. Press
the or button to change channel number. Display will read ʺOKʺ,
ʺNoneʺ, or ʺFailed.ʺ Press ESC to return to normal display.
the or button to change channel number. Display will read ʺOKʺ,
ʺNoneʺ, or ʺFailed.ʺ Press ESC to return to normal display.
If a ʺFailedʺ condition is detected, make sure the Cat 5 UTP cable is
installed properly and secured, or try using another CIM to see if the CIM
under test has become defective.
installed properly and secured, or try using another CIM to see if the CIM
under test has become defective.
Test Stack Unit:
Press the or button to select the corresponding Stacking Unit ID for
any connected units. If there are no Stacking Units connected, the LCD
will display ʺNone.ʺ If there are Stacking Units connected, the LCD
should read ʺOKʺ for each unit. Press ESC to return to normal display.
any connected units. If there are no Stacking Units connected, the LCD
will display ʺNone.ʺ If there are Stacking Units connected, the LCD
should read ʺOKʺ for each unit. Press ESC to return to normal display.
Stacking Support:
Press the or button to set the Stacking Unit ID number (0~3 for a
P2‐UMT832M or 0~1 for a P2‐UMT1664M). The default is set to ʺ0ʺ (no
Stacking Units connected). If you wish to add Stacking Units, this number
must be equal to the number of Stacking Units connected. Press ENT to
save the value or ESC to cancel and return to normal display.
P2‐UMT832M or 0~1 for a P2‐UMT1664M). The default is set to ʺ0ʺ (no
Stacking Units connected). If you wish to add Stacking Units, this number
must be equal to the number of Stacking Units connected. Press ENT to
save the value or ESC to cancel and return to normal display.
Set LCD Contrast:
Modifies contrast level of front panel LCD Display. Press the or
button to increase or decrease contrast, and press the ESC button to
return to normal display.
button to increase or decrease contrast, and press the ESC button to
return to normal display.