Roland VG-99 用户手册
45
Chapter 4 Global Device Settings (SYSTEM)
Chapter 4
Adjust the Divided pickup sensitivity for each string.
1.
2.
Press PAGE [
] to display Page 4.
3.
Rotate the F1–F6 knobs to adjust the
sensitivity.
sensitivity.
Play each open string with the maximum force you’d use in an
actual performance, and set the sensitivity such that the meter
registers a level just before reaching the maximum level.
actual performance, and set the sensitivity such that the meter
registers a level just before reaching the maximum level.
*
If the large segments at the right end of the level meter appear, it
means the level is set too high. Lower the sensitivity setting.
*
Pressing [F1]–[F6] initializes each string’s value to 65.
*
Depending on the guitar you use, the level meter may move to the
maximum level even when the sensitivity is set to the minimum
setting. If this occurs, adjust the clearance separating the divided
pickup and the strings so the distance is slightly greater than
specified.
4.
Play the sixth through first strings with the
normal amount of force; if any strings sounds
particularly loud, lower the sensitivity setting
for that string, and keep adjusting until the
differences in the strings’ volume levels are
minimal.
normal amount of force; if any strings sounds
particularly loud, lower the sensitivity setting
for that string, and keep adjusting until the
differences in the strings’ volume levels are
minimal.
The VG-99 comes equipped with a function that automatically
determines whether or not a GK connection exists and switches the
internal settings accordingly. This makes it possible for you to all
functions other than a COSM guitar (COSM amp, effects, tuner, etc.)
when you’ve connected only to the GUITAR INPUT.
determines whether or not a GK connection exists and switches the
internal settings accordingly. This makes it possible for you to all
functions other than a COSM guitar (COSM amp, effects, tuner, etc.)
when you’ve connected only to the GUITAR INPUT.
1.
2.
Press PAGE [
] to display Page 1.
3.
Use [F1] (SELECT) or the F1 knob to select the
setting.
setting.
*
You should ordinarily use AUTO (the default setting). In cases
where the auto-detect function does not operate correctly, (for
example, when you are using a Divided pickup other than the GK-3),
pickup, use [F2] or the F2 dial to change the setting.
Adjusting the Sensitivity for Each
String
String
Settings
Explanation
0–100
Adjust the input sensitivity of each Di-
vided pickup.
vided pickup.
Setting Whether or Not the Deviced
Pickup Is Used (GK CONNCT)
Pickup Is Used (GK CONNCT)
Settings
Explanation
AUTO
The presence of a GK connection is detected au-
tomatically and the internal settings are
switched accordingly.
tomatically and the internal settings are
switched accordingly.
ON
Settings appropriate for a GK connection are al-
ways used.
ways used.
OFF
Settings appropriate for a GUITAR INPUT con-
nection are always used.
nection are always used.
VG-99_e.book 45 ページ ２００７年７月５日 木曜日 午前９時２２分