Runco V-50HD 用户手册

• E-Mail Notification: Select E-Mail Notification from the Network menu to specify 

when and to whom the DHD Controller sends error and service notification messages 
via e-mail.

The notification messages are in the following format:

To:  [E-Mail Address; see below]
From:  do-not-reply@runco.com
Subject:  [Type of notification] from Runco DHD-LS
Body:  

This is an automated message sent from the Runco DHD-LS:

Notification:

[One of the following:
“DHD Error” / “Display Error” 
“Periodic Service Notification”
“Calibration Data”]

Detailed Description: [ If a DHD Error, one of the following:

“Fan Failure 1” / “Fan Failure 2”
“Overtemp 1” / “Overtemp 2”
“Initialization Failure”

If a Display Error, a device-specific 
error message 

If a Periodic Service Notification, the elapsed
time since the last notification

If a Calibration Data message, 
“See Attached File” ]

Serial Number:

[DHD Controller serial number]

Customer Information: [From “Customer Information” sub-menu; 

see below]

Best Regards,

Runco International, LLC
1195 NW Compton Drive
Beaverton, OR 97006
1-800-237-8262

• E-Mail Address: To specify the destination e-mail address for error and service 

notifications, select E-Mail Address from the E-Mail Notification menu. The 
procedure is similar to that for setting the IP address (refer to IP Configuration on 
page 48). Enter up to 45 alphanumeric characters. 

• Error Notification: To have the DHD Controller send a message to the destination 

e-mail address when a “DHD Error” or “Display Error” occurs, select Error 
Notification from the E-Mail Notification menu and set it to On. 

• Error Notification to Runco: To have the DHD Controller send an e-mail message 

to Runco Customer Support when a “DHD Error” or “Display Error” occurs, select 
Error Notification to Runco from the E-Mail Notification menu and set it to On.