Runco Q-1500d/Cinewide with Auroscope 用户手册

Table 3-1 gives a quick overview of the Q-1500d installation process. The sections 
following this one provide detailed instructions. 

1

Choose a location for the projector

2

Install CineWide lens mounting assembly (stationary base 
plate or AutoScope lens motor – optional)

3

Mount the projector

4

Mount the Primary DHD Controller, Secondary DHD 
Controller and Brightness Acceleration Engine 

5

Connect the Primary and Secondary DHD Controllers to 
the projector

6

Connect the Brightness Acceleration Engine to the Primary 
and Secondary DHD Controllers 

7

Connect other external equipment to Primary DHD 
Controller (optional):
• Audio processor or secondary display device
• Control system interface (RS-232)
• 12-volt trigger-activated equipment (retractable screens 

or screen masking)

• External IR repeater
• Network hub, router or gateway (Ethernet)

8

Connect signal sources to the Brightness Acceleration 
Engine

9

Connect system components to AC power 

10

Power up the system and perform optical alignment 
procedures (refer to Table 3-6)

11

Display calibration —Primary DHD Controller: set 
Adjustment Mode to Primary; adjust the following for each 
input and display mode (resolution and frame rate); save 
settings when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Sharpness
• White Balance

12

Display calibration —Secondary DHD Controller: set 
Adjustment Mode to Secondary; repeat Step 11