Winegard SK-7003 用户手册

Press [Select] to cycle through each of these satellites until the asterisk is next to the satellite you wish to find. 

Then press [Enter].

The TRAV’LER Interface will ask you to confirm the change:

Press [Select] to move the asterisk to YES. 

                                         

 The Trav’ler Interface will acknowledge your selection and ask:

 

                         

Pressing [Enter] or choosing YES, will stow the TRAV’LER and turn it off.

Pressing [Select] then [Enter] or choosing NO will start a new search for your chosen satellite.

The Winegard TRAV’LER antenna comes with an emergency Power Off feature.To activate it, press 

and hold [POWER] and then press [SELECT] while still holding [POWER]. The TRAV’LER antenna  will 

stop where it is and turn off.

 

If the Emergency Power Off is used, the TRAV’LER antenna may not be in a safe position for 

travel. 

5

!

The TRAV’LER will remain in 

manual mode until you select 

multi-sat mode again.

To use the Manual Search Mode to select a specific satellite, choose Search Mode by pressing the [Enter] button.

Once in the Search Menu you may choose from:

MULTISAT MODE (The normal search mode)

MANUAL 61

MANUAL 72

MANUAL 82

MANUAL 91

MANUAL 101

MANUAL 107

MANUAL 110

MANUAL 111

MANUAL 119

MANUAL 129

MANUAL 148

MAIN MENU (returns to the User Menu)
EXIT (Enters the Search Routine)

To stow the unit when you are ready to travel:

Press [Power] one time.

                      

The unit will stop what it is doing and begin to return to the stowed position. The TRAV’LER Interface WILL NOT 

TURN OFF unless the TRAV’LER mount is successfully stowed.

The TRAV’LER antenna is an extremely versatile satellite antenna and can be manually set to find many different 

satellites individually. 

NOTE: This function is rarely used. 

To enter the Manual Search Mode while the TRAV’LER is stowed:

Press the [Power] button and hold it for two seconds to turn the unit on.

While the Trav’ler Interface reads: 

                                       

Press and hold the [Enter] button for two seconds.

The TRAV’LER Interface will ask if you wish to enter the User Menu:

                                                 

Press [Select] to choose YES and then press [Enter].

The User Menu consists of four choices:

Diagnostics

Installation

Exit

NOTE: Diagnostic and Installation Menus are not required for normal operation and should only be entered by a 

trained professional.

4

!

The SK-7003 will only see 

the 107° and 111° satellites in 

manual mode.