Maxon Telecom SP210 用户手册
Maxon SP200/210 Radio SP200/210
INSTALLATION, COMMISSIONING & ALIGNMENT -
Issue 1.0
Page 4-8
03/01
4.5 Alignment
CAUTION
This radio contains static sensitive devices.
Static safe precautions should be observed, in
particular we would recommend the use of a
suitable floor mat, table mat, bonding cords
and a wrist strap. The soldering iron should
have an earthed tip.
Static safe precautions should be observed, in
particular we would recommend the use of a
suitable floor mat, table mat, bonding cords
and a wrist strap. The soldering iron should
have an earthed tip.
Care should be exercised in the handling of
static sensitive components and they should
always be transported in the correct
containers.
static sensitive components and they should
always be transported in the correct
containers.
Never remove, or insert, static sensitive
devices with the power applied.
devices with the power applied.
4.5.1 Preparation
To perform the following tests it is necessary
to program the radio as follows:
to program the radio as follows:
VHF
Ch.
Tx(MHz)
Rx(MHz)
CTCSS
1
146.025
146.025
None
2
160.025
160.025
None
3
173.975
173.975
None
4
173.975
173.975
67Hz
5
173.975
173.975
250.3
6
146.025
146.025
None
7
160.025
160.025
None
8
173.975
173.975
None
9
173.975
173.975
67Hz
10
173.975
173.975
250.3
UHF
Ch.
Tx(MHz)
Rx(MHz)
CTCSS
1
440.025
440.025
None
2
455.025
455.025
None
3
469.975
469.975
None
4
469.975
469.975
67Hz
5
469.975
469.975
250.3
6
440.025
440.025
None
7
455.025
455.025
None
8
469.975
469.975
None
9
469.975
469.975
67Hz
10
469.975
469.975
250.3
Channel spacing as required. Channels 1 to 5
should be set to Low Power and channels 6 to
10 set to High Power.
should be set to Low Power and channels 6 to
10 set to High Power.
Ensure that the Power Save is OFF.
Tests without Disassembly
Power Output, Deviation, Balance and
Squelch adjustment do not require the radio to
be disassembled.
Squelch adjustment do not require the radio to
be disassembled.