Motorola RMV2080 用户手册

English

Return to ‘Idle’ Programming Mode and start 
over. You will not be able to return to 
Programming Mode (the radio does not provide 
further way to let you know the specific stage 
you are at in the Programming Mode). 
Therefore you can:

•

Long press the PTT button. The radio will return 
to ‘Idle’ Programming Mode or,

•

Turn OFF the radio and enter Programming 
Mode again. (Refer to “Entering Advanced 
Configuration Mode” on page 33 for more 
information)

The radio disallow you to program any value 
that is not available in the frequencies and 

codes pool. For example, if you try to program 
code 220, the radio would not accept it as the 
maximum value allowed is 219. Same goes for 
the frequencies. Refer to the“Frequency and 
Code Charts” on page 58 to make sure you are 
programming a valid value.

The radio may be locked using the CPS to 
disallow Front Panel Programming. To re-
enable, use the CPS.

If you programmed the wrong value, you can 
either:

•

‘Roll-over’ the radio. The radio ‘roll-over’ each 
time it reaches the maximum value allowed. Keep 
increasing (short press the SB1 button) or 
decreasing (short press the SB2 button) until you 
get the desired value or,