Motorola XTS 3000 用户手册
Introduction
9
Universal Connector Cover
Installation and Removal
Installation and Removal
Installing the Universal Connector Cover
1. Looking at the antenna side of the
radio, insert the top (flat) hooked
end of the cover into the slot on the
top of the radio, above the universal
connector. Press downward on the
cover’s top to seat it in the slot.
end of the cover into the slot on the
top of the radio, above the universal
connector. Press downward on the
cover’s top to seat it in the slot.
2. While holding the cover seated in
the top slot, insert the cover’s
bottom (rounded) hooked end into
the slot below the universal
connector. Press firmly inward on
the cover’s bottom until it snaps in
place.
bottom (rounded) hooked end into
the slot below the universal
connector. Press firmly inward on
the cover’s bottom until it snaps in
place.
Removing the Universal Connector Cover
1. Looking at the antenna side of the
radio, insert a flat-bladed screwdriver
into the area between the lower end
of the universal connector cover and
the slot below the universal
connector.
into the area between the lower end
of the universal connector cover and
the slot below the universal
connector.
2. Pry upward on the cover’s lower end
until it disengages from the radio.
CAUTION
When the universal connector is not in use, keep it covered with the
universal connector cover.
!
Top
Slot
Bottom
Slot
Top
Hooked End
Bottom
Hooked End
Model I Book Page 9 Wednesday, August 14, 1996 8:51 AM