Motorola XTNi Series 用户手册

 

6. Place the Source radio” in its SUC, press

 

and release SB1.
7. After cloning is completed, the Source radio 
will sound either a “pass” tone (cloning was 
successful) or a “fail” tone (cloning process has 
failed). The ‘pass’ tone sounds like a good key 
‘chirp’ whereas the ‘fail’ tone sounds similar to 
a ‘bonk’ tone. If the Source radio is a display 
model it will either show ‘Pass’ or ‘Fail’ on the 
display (a tone will be heard in no more than 5 
seconds).
8. Once you have completed the cloning 
process, turn the radios OFFand ON in order 
to exit ‘clone’ mode. 

The radio will emit an audible ‘bonk’ indicating

 

that the cloning process has failed. In the event

 

that cloning fails, try performing each of the

 

following before trying to start the cloning

 

process again:

1. Ensure that the batteries on both radios are 
fully charged.
2. Check the cloning cable connection on both 
SUCs.
3. Ensure that the battery is engaged properly 
on to the radio.
4. Ensure that there is no debris in the 
charging tray or on the radio contacts.
5. Ensure that the Source radio is in cloning

 

mode.
6. Ensure that the Target radio is turned ON.
7. Ensure both radios are both from the same 
type. (same frequency band, same front panel 
(display/non display), same region and same 
transmission power).

Attention: This cloning cable is designed to

 

operate only with compatible Motorola

 

RLN6170 (Rapid) Single Unit Charger.

When ordering Cloning Cable please refer to 
P/N RLN6303. For details about accessories 
refer to “Accessories” section.