Motorola CLP1010 用户手册
PROGRAMMING THE RADIO
THR
O
UGH CPS
20
2.
Make sure the radio is turned ON.
3.
Once the radio is connected, open the CPS and
select “Read” on the toolbar to get the radio
profile. The CPS allows the user to change
settings, such as General, Audio, Menu,
Channels, Scan List, as well as select
frequencies, PL/DPL codes on each channel.
select “Read” on the toolbar to get the radio
profile. The CPS allows the user to change
settings, such as General, Audio, Menu,
Channels, Scan List, as well as select
frequencies, PL/DPL codes on each channel.
4.
After you change the settings, press “Write” on
the toolbar to save the settings.
the toolbar to save the settings.
For more information on the Computer Programming
Software, please refer to Help menu on the CPS.
Software, please refer to Help menu on the CPS.
Note:
(*) CPS Programming Cable (P/N HKKN4025) is an
accessory sold separately. Please contact your
Motorola Point of Purchase for more information.
accessory sold separately. Please contact your
Motorola Point of Purchase for more information.
Factory Default Settings
Your radio is programmed at the factory to the
following settings:
following settings:
CLP1010 1W UHF 1 CH Radios Default Settings - BRUS
Channel
#
Frequency
#
Frequency
Setting
Code
Value
(Hz)
Band
width
(kHz)
width
(kHz)
1
2
464.5500
67
12.5
CLP1040 1W UHF 4 CH Radios Default Settings - BRUS
Channel
#
Frequency
#
Frequency
Settings
Code
Value
(Hz)
Band
width
(kHz)
width
(kHz)
1
2
464.5500
67
12.5
2
8
467.9250
67
12.5
3
5
467.8500
67
12.5
4
6
467.8750
67
12.5