用户手册目录Master Table of Content6Safety2Section A - Installation7Section B - Operation15Section C - Accessories27Section D - Maintenance29Section E - Theory of Operation33Section F - Troubleshooting and Repair39Symptoms42Major physical or electrical damage is evident when the sheet metal cover(s) are removed.42The LN-15 does not “power-up” when the on/off switch is turned to the ”ON”position.42When the gun trigger is activated the wire drive runs and electrode wire feeds, but there is no welding output.42When the gun trigger is activated there is no wire feed.43The wire feeds for a short period of time but then stops feeding. When the gun trigger is released then re-activated the wire resumes feeding but soon stops again.43The wire stops or stubs while welding.44The wire feed speed range is only 50 to 374 IPM.(1.3 to 9.5m/min.44The wire feed speed range is only 50 to 600 IPM.(1.3 to 15.3 m/min)44The wire feed motor runs very fast and there is no control.45The wire feed speed varies during welding but the meter reading remains constant.45No shielding gas.46The shielding gas turns on sporadically, or remains on all the time.46The Display board shows “POS” “PRE” or “BRN”.46There is porosity in the weld.46The welding arc burns back to the tip.46Section G - Electrical Diagrams83文件大小: 2.6 MB页数: 93Language: English打开用户手册