Samsung DV438. Benutzerhandbuch

4

To avoid risk of electrical shock, personal injury or death; disconnect power to dryer 

before servicing, unless testing requires power.

ALIGNMENT AND ADJUSTMENTS

Sensor Bar Touch Data Mode
Definition of Sensor Bar Touch Data Mode:

-  While in Power On pressing Signal and Temp Keys for 3 seconds

-  This action will put the dryer into sensor bar touch data mode

-  Dryer will display Sensor Bar data. This mode is default mode of entering service mode
How to Enter:

-  While in Power off pressing Signal and Temp Keys for 3 seconds 

Cycle Count Mode
Definition of Cycle Count Mode:

-  While in Service Mode pressing the Signal key will put the dryer into the cycle count mode

-  Cycle number executed will display.
How to Enter:

-  To enter Special Test Mode press While in Service Mode pressing the Signal key for 3 

  seconds or until the control beep.

Software Version Mode
Definition of Software Version Mode:

-  While in Service Mode pressing the Temp key will put the dryer into the software version 

  mode

How to Enter:

-  To enter Special Test Mode press Temp Key until the control beep.

  ex) In case of “U05”, U0 means major version “v“ 05 means minor version “05”

Special Test Mode:

-  While in Power Off, pressing the Dryness Level + Power keys simultaneously will put the 

  dryer into the System Check mode

-  “ t2 “ will display.

-  System Check Mode Progress

  t2 mode Function Performed Start/Pause Motor(CW) Relay On → Heater Relay On → 

  Heater Relay Off → Motor(CW) Relay Off (Circulation)

Technical_information-02365B.ind4   4

2008-06-25   ¿ÀÈÄ 5:24:23