Regency P33-NG4 Benutzerhandbuch

Regency

®

 P33-4 Zero Clearance Direct Vent Gas Fireplace

44

1)  Shut off the gas supply.

2)  Remove the louvers (and bay door if it is 

on).

3)  Open the fl ush door and remove the door.

4)  Remove the logs.

5)  Remove the burner/grate assembly by 

removing the two Phillips head screws and 
then lift the burner assembly out.

6)  Remove the rear log stand by removing the 

2 screws.

7)  Disconnect the inlet gas line. See diagram 

2.

8)  Disconnect the 2 TP wires and the 2 TH 

wires from the valve.

9)  Remove the 10 Phillips head screws securing 

the valve tray assembly in place (diagram 2) 
and then lift the entire assembly out (diagram 
3).

Rear Log Stand

screws

1)  Attach the valve to the valve bracket with 

the 4 (m5x8 metric) screws provided.

2)  Reconnect the "gas out" fl are fi tting with 

an 11/16" wrench.

3)  Reconnect the "gas out" fl are nut with a 

13/16" wrench.

4)  Install piezo ignitor push button assembly 

and reconnect wire.

5)  Reconnect the quick drop out thermocouple 

nut with a 9mm wrench.

6)  Reconnect the pilot tube nut with a 7/16" 

wrench.

7)  Scrape off the old gasket from the fl oor 

of the fi rebox and from the valve tray 
assembly.

8)  Install a new gasket and reinstall the valve 

tray assembly.

9)  Reinstall the 10 hold down screws.

10) Hook up the 2 TP and 2 TH wires to the 

appropriate connections on the valve.

11) Reinstall the front log stand.

12) Install Burner/grate assembly.

13) Hook up the gas line and check for gas 

leaks with a soap and water solution or a 
gas leak detector. (Do not use open fl ame 
for leak testing.)

14) Fire up the unit temporarily.

15) Check the manifold pressure.

16) Reinstall the logs and brick panels as 

needed.

17) Close the door and replace the louvers.

18) Fire up the unit again and check for proper 

fl ame appearance and glow on logs.

10) Undo the pilot tube from the valve with a 
 7/16" 

wrench.

11) Undo the quick drop out thermocouple nut 

on the valve with a 9mm (metric) wrench.

12) Remove the Piezo igniter wire and push 

button assembly.  

13) Undo the "gas out" fl are nut with a 13/16" 

wrench.

14) Undo the "gas out" fl are fi tting with an 11/16" 

wrench.

15) Remove the 4 Phillips head screws from 

the sides of the valve bracket and remove 
valve.