Samsung HTH5500W Benutzerhandbuch
12
- English
Connections
✎
The maximum transmission distance from the product to the wireless receiver module is about 10m,
but may vary depending on your operating environment. If a steel-concrete wall or metallic wall is
between the product and the wireless receiver module, the system may not operate at all, because
the radio waves cannot penetrate metal.
but may vary depending on your operating environment. If a steel-concrete wall or metallic wall is
between the product and the wireless receiver module, the system may not operate at all, because
the radio waves cannot penetrate metal.
✎
If the product doesn't make a wireless connection, you need to run an ID Set between the product
and wireless receiver module. With the product turned off, press "0""1""3""5" on the remote
control. Turn on the wireless receiver module. Then, press and hold the "Id SET" button on the back
and wireless receiver module. With the product turned off, press "0""1""3""5" on the remote
control. Turn on the wireless receiver module. Then, press and hold the "Id SET" button on the back
of the wireless receiver module for 5 seconds, and then turn the product on.
| CAUTION |
▶ If you want to install the speakers on the wall, fasten screws or nails (not provided) firmly to the wall
wherever you want to hang a speaker, and then, using the hole in the rear of each speaker, carefully
hang each speaker on a screw or nail.
hang each speaker on a screw or nail.
▶ Do not let children play with or near the speakers. They could get hurt if a speaker falls.
▶ When connecting the speaker wires to the speakers, make sure that the polarity (+/ –) is correct.
▶ Keep the subwoofer speaker out of reach of children to prevent children from inserting their hands
or alien substances into the duct (hole) of the subwoofer speaker.
▶ Do not hang the subwoofer on the wall using the duct (hole).
▶ The wireless receiving antenna is built into the wireless receiver module. Keep it away from water
and moisture.
▶ For optimal listening performance, make sure that the area around the wireless receiver module
location is clear of any obstructions.
▶ In 2-CH mode, you will hear no sound from the wireless surround speakers.
Attaching the Toroidal Ferrite Core to the Power Cord of the Wireless Receiver
Module (SWA-6000)
* HT-H5500W/HT-H5550W only
If you attach a Toroidal ferrite core to the power cord of the wireless
receiver module, it will help prevent RF interference from radio signals.
If you attach a Toroidal ferrite core to the power cord of the wireless
receiver module, it will help prevent RF interference from radio signals.
1. Pull the fixing tab of the Toroidal ferrite core to open it.
2. Make two loops in the wireless receiver module power cord.
3. Attach the Toroidal ferrite core to the wireless receiver module
2. Make two loops in the wireless receiver module power cord.
3. Attach the Toroidal ferrite core to the wireless receiver module
power cord as shown in the figure on the right, and then close it
by pressiing it until it clicks.
by pressiing it until it clicks.
●
Attach the ferrite core as close to the Wireless Receiver Module
as possible.
as possible.