Hoover S3621 Benutzerhandbuch

When agitator brush roll brushes are
worn, the brush roll should be replaced.

To check condition of brushes, move
edge of a card across bottom plate while
turning brush roll.  To maintain cleaning
effectiveness, replace brush roll if brush-
es do not touch card.

When purchasing a new agitator brush
roll, ask for HOOVER 

1.  Remove hood, duct cover, belt and
brush roll as shown in Figs. 3-9 to 
3-14.

2.  Discard old brush roll.

3.  Replace new brush roll and belt as
shown in Figs. 3-15 to 3-17. 

2. Push old bulb into socket and twist to
remove.  Push new bulb into socket and
twist into place.
3. Replace hood.

The headlight, located on top of the
power nozzle, operates when the clean-
er is turned on.  Use only HOOVER

, which is a fused

bulb, when replacing the headlight. 

1. Remove the hood as shown in Figs.
3-9 and 3-10.

Position hood on top of nozzle base.  

Turn nozzle over. Replace 2 short screws
at the back of nozzle and 2 long screws
at the front.

Replace brush roll cover (C) over agitator
brush roll.  Replace 3 short screws.

Lift up end of agitator brush roll.  Remove
old belt from agitator pulley (E) and
replace with new belt.  Lettering on belt
must be visible.

Stretch belt back and attach to motor
pulley.

Hold opposite end of agitator brush roll
in place.  Push belt end forward, rotating
end plate (F) until it slides into place.
Turn agitator, making sure it rotates freely.

An internal thermal protector has been
used in your cleaner to prevent over-
heating if a large item or clog gets
caught in the nozzle or at the opening of
the bag. 

If this happens, turn cleaner OFF and

Then disconnect nozzle and

remove obstruction. Within 15 minutes
the thermal protector will cool and auto-
matically reset and cleaning may
resume.  
If cleaner does not operate, allow addi-
tional time for thermal protector to reset

.