Sony Security Camera Benutzerhandbuch
Installation
14
4
Use the supplied round head screws to secure the
NSR to the rack.
NSR to the rack.
* The remainder of this manual uses illustrations and screens
of the NSR-100/50.
Connecting a Monitor
Connect the monitor to the monitor1 connector on the
rear of the recorder.
rear of the recorder.
Connecting the Keyboard, Mouse
and Remote Control Unit
(RM-NS10)
and Remote Control Unit
(RM-NS10)
1
Connect the keyboard to the USB connector on the
rear (or front) of the recorder.
rear (or front) of the recorder.
2
Connect the mouse or the remote control unit
(RM-NS10) to the USB connector.
(RM-NS10) to the USB connector.
Note
When using the NSR-25, only the two USB
connectors on the rear of the unit are available.
Connecting a keyboard and mouse makes setting up
for the first time easier.
connectors on the rear of the unit are available.
Connecting a keyboard and mouse makes setting up
for the first time easier.
Connecting the Power Cord
1
Connect the power cord to the power supply
connector at the rear of the NSR, and then connect
the other end to the power outlet.
connector at the rear of the NSR, and then connect
the other end to the power outlet.
2
Lift the power cord safety clip and snap it around
the power cord to prevent it from disconnecting.
the power cord to prevent it from disconnecting.
Note
Before installing, carefully read “Important
Information About Safety” (page 3). When using
more than one NSR, also make sure to have
sufficient power capacity.
Information About Safety” (page 3). When using
more than one NSR, also make sure to have
sufficient power capacity.
Connecting the Network Cable
Connect the network cable.
Connect the one end of the network cable to one of the
LAN connectors at the rear of the NSR. Connect the
other end to the network switch.
Connect the one end of the network cable to one of the
LAN connectors at the rear of the NSR. Connect the
other end to the network switch.
Round head
screw
screw
1
To the power
outlet
outlet