Husqvarna T536 Benutzerhandbuch

20 – English

•

Check that the chain brake is in disengaged position 
by moving the front hand guard towards the front 
handle.

•

Unscrew the bar nut and remove the drive sprocket 
cover. Remove the transportation guard (A).

•

Fit the bar over the bar bolt. Place the bar in its 
rearmost position. Place the chain over the drive 
sprocket and in the groove on the bar. Begin on the top 
side of the bar. 

•

Make sure that the edges of the cutting links are facing 
forward on the top edge of the bar.

•

Fit the drive sprocket cover and locate the chain 
adjuster pin in the cut-out in the guide bar. Check that 
the drive links of the saw chain fit correctly on the drive 

sprocket and that the saw chain is in the groove in the 
guide bar. Tighten the bar nut finger-tight.

•

Tension the chain by turning the chain tensioning 
screw clockwise using the combination spanner. The 
chain should be tensioned until it does not sag from 
the underside of the bar. See instructions under the 
heading Tensioning the chain.

•

The chain is correctly tensioned when there is no 
slack on the underside of the bar, and it can still be 
turned easily by hand. Tighten the bar nut with the 
combination spanner while holding up the tip of the 
bar. 

•

When fitting a new chain, the chain tension has to be 
checked frequently until the chain is run-in. Check the 
chain tension regularly. A correctly tensioned chain 
ensures good cutting performance and long life.

To fit a spike bumper – contact your service agent.

Li-ion

Li-ion