Fujitsu PG-LND101 Benutzerhandbuch
6 VLAN
73
E
6.2
Creating VLAN
Perform the following procedures to create a VLAN.
1
Log on with administrator privileges.
2
Set the port of the switch connected to the Ethernet controller to
enable send/receive of VLAN tag frames.
enable send/receive of VLAN tag frames.
3
Click [Start] → [Settings] → [Control Panel] → [Intel®PROSet
Wired], and start Intel
Wired], and start Intel
®
PROSet.
4
Select LAN adapter to set VLAN, and right click.
A VLAN cannot be set to an adapter composing a team.
5
Click [Add VLAN].
6
Set [ID] and [Name], then click [OK].
[ID] must be the same as the set values on the switch. The available range to set is 1 to 4094.
[Name] does not need to be the same as the setting on the switch.
When the confirmation message appears, select [Yes].
[Name] does not need to be the same as the setting on the switch.
When the confirmation message appears, select [Yes].
7
Repeat Steps 4 through 6 to set respective VLANs.
8
Click [OK] and exit Intel
®
PROSet.
When configuring a VLAN is completed, a virtual adapter "Intel(R) Advanced Network
Services Virtual Adapter" will appear.
Upper layer protocol is bound to this virtual adapter.
You cannot bind them with the Ethernet controller that makes up a Team.
IP address is set in this virtual adapter.
Services Virtual Adapter" will appear.
Upper layer protocol is bound to this virtual adapter.
You cannot bind them with the Ethernet controller that makes up a Team.
IP address is set in this virtual adapter.
9
Restart the system.