TP-LINK TD-W8960N Benutzerhandbuch
TD-W8960N
300Mbps Wireless N ADSL2+ Modem Router User Guide
18
This Advanced Setup section mainly introduces how to configure the Router for adequate use.
The detailed explanations for each subsection are provided below.
The detailed explanations for each subsection are provided below.
)
Note:
To completely configure the WAN Interface, you need to first select the Layer2 Interface (
) according to the connection ISP provides you, and then to select the type of the
connection (
4.4.1 Layer2 Interface
Choose “Advanced Setup”Æ“Layer2 Interface”, and you can select WAN Service Interface
(layer2 interface) over ATM interface or ETH interface.
(layer2 interface) over ATM interface or ETH interface.
¾
ATM Interface: Configure the Router to access Internet as an ADSL user. ISP provides you
VPI (Virtual Path Identifier), VCI (Virtual Channel Identifier) settings and the DSL Interface
with RJ11 connector. (Figure 2-1)
with RJ11 connector. (Figure 2-1)
¾
ETH Interface: Configure the Router to access Internet as an Ethernet user. ISP provides
you Broadband Internet Service and the Ethernet Interface with RJ45 connector.
4.4.1.1 ATM interface
Choose “Advanced Setup”Æ“Layer2 InterfaceÆATM interface”, you can Configure ATM
interfaces on the screen below.
interfaces on the screen below.