APC AP9607 Benutzerhandbuch

15

Handle the Interface Expander by the front panel. Do not 
touch the exposed printed circuit board or components. 
Touching the circuit board or components may result in 
damage to the Interface Expander.

Before you install the Interface Expander, install any 
required power management software (PowerChute, Power-
Chute plus, or software required by your operating system). 
If you plan to use PowerChute plus on servers connected to 
the Basic ports of the Interface Expander, see “Master 
server versus Interface Expander servers” on page 8 and 
“Configuring PowerChute plus for simple signaling” on 
page 9.

 

To install the Interface Expander, perform the following 
steps in the order given.

SmartSlot device, refer to “Multiple SmartSlot Instal-
lation” on page 12 before proceeding.

1 Turn off the 

UPS

 or device that will house the 

----

Interface Expander. To turn off the UPS:

a Unplug the UPS.

b Turn off the UPS output by pressing the 

Off button for at least 5 seconds.

2 Unpack the Interface Expander. The shipping 

materials are recyclable. Please reuse or dispose of 
them appropriately.

3 Use a #2 Phillips head screwdriver to remove the 

two screws fastening the accessory slot cover on 
the back panel of the UPS or device. Keep the 
screws for Step 5 below. Save the accessory slot 
cover for future use (e.g., shipping the 

UPS

).