APC AP9607 Benutzerhandbuch
16
Installation
procedure,
continued
4 Orient the Interface Expander to fit the accessory
slot. Slide the Interface Expander all the way into
the slot until the front panel is flush with the back
panel of the
the slot until the front panel is flush with the back
panel of the
UPS or device
.
Note: While it is not possible to install the Inter-
face Expander upside down, it is possible to
damage the unit in the attempt to do so.
Observe the correct orientation as shown
below. Note that the sides of the printed cir-
cuit board align with the card guides in the
sides of the accessory slot. The accessory
slot in the
damage the unit in the attempt to do so.
Observe the correct orientation as shown
below. Note that the sides of the printed cir-
cuit board align with the card guides in the
sides of the accessory slot. The accessory
slot in the
UPS
or device may be oriented
horizontally or vertically.
5 Secure the Interface Expander with the screws