Printek Mt3-II Benutzerhandbuch

 

The printer can print text, bar codes and some limited graphics on thermal receipt paper.  See “Media 
Specifications” for the width, thickness requirements and approved vendors. 

Follow these steps to load printer paper:  

 

1.  Open the paper supply door by placing your fingers under 

the “T” pull lever and pulling up firmly on the supply 
cover until the lever stops moving.  

 

Note: Do not pull too hard.  Use enough force to allow the 

cover to unlock and lift freely 

2.  Place the paper supply roll into the paper supply well.  

Make sure the paper supply unwinds from the bottom as 
shown. 

3.  Position the paper supply between the print head guides. 

4.  Make sure some supply (2-3 inches) extends beyond the 

top of the paper supply well. 

5.  Close the paper supply door. 

 

 

 

 

 

 

The printer’s paper supply door acts as a tear bar.  Pull one edge of the paper against the tear bar as shown 
below, then tear down and across against the tear bar to remove receipts. 

 

Using the tear bar is the only way to tear the 
paper.  Pulling up and pulling sideways 
without using the tear bar may cause the 
paper door to open and the paper roll to fall 
out. 

 Caution: The tear bar may have sharp edges. 

 

 

 

7