ATTO Technology 2700C Benutzerhandbuch
21
ATTO Technology Inc. iPBridge Installation and Operation Manual
3.1 ATTO ExpressNAV pages
Each page in the ATTO ExpressNAV interface provides information and/or configuration parameters
based on a specific topic. Each page can be reached through the menu at the side of each page An image
on each page’s header shows each port in the product faceplate. Each port is clickable and will also take
you to the appropriate page.
Status
Displays iPBridge information
based on a specific topic. Each page can be reached through the menu at the side of each page An image
on each page’s header shows each port in the product faceplate. Each port is clickable and will also take
you to the appropriate page.
Status
Displays iPBridge information
• Bridge
name
• Vendor
ID
• Product
ID
• Firmware revision number
• Serial
• Serial
number
• Valid
temperature
range
• Current
temperature
• Current
voltage
• Ethernet port IP addresses
• Ethernet
• Ethernet
port
status
• Fibre Channel port status
• World Wide Name identifiers for Fibre Channel
• World Wide Name identifiers for Fibre Channel
ports and iSCSI nodes
Serial Port Configuration
Configure the baud rate and echo parameters.
Refer to
Configure the baud rate and echo parameters.
Refer to
page 47 for details on each option.
Time & Date Configuration
Configures the real-time clock or accesses a
remote time server. Configurable options are
Time & Date Configuration
Configures the real-time clock or accesses a
remote time server. Configurable options are
• Enable/disable Simple Network Time Protocol
• Time
• Time
Server
• Time
Zone
• manually set time
• manually set date
• manually set date
Refer to
on page 41 for
details each parameter.
Ethernet (Network) Port Configuration
Displays available ports and configures each port
independently for the following parameters
Ethernet (Network) Port Configuration
Displays available ports and configures each port
independently for the following parameters
• Enable/disable
DHCP
• IP
address
• IP
gateway
• IP
subnet
mask
• Ethernet
speed
• MTU
details on each parameter.
SNMP
Configures Simple Network Management
Protocol parameters and Trap recipient IP address
for each Ethernet port. Refer to
SNMP
Configures Simple Network Management
Protocol parameters and Trap recipient IP address
for each Ethernet port. Refer to
on page 49 for details.
Fibre Channel Configuration
Each Fibre Channel port is configured separately.
The page displays the Port Name and Node Name
for each port. Choose the port to display a list of
attached devices for each bus. Configurable
options are
Each Fibre Channel port is configured separately.
The page displays the Port Name and Node Name
for each port. Choose the port to display a list of
attached devices for each bus. Configurable
options are
• Hard Address assignment
• Data
• Data
rate
• Connection
mode
• Hard Address values
on page 48 for details.
iSCSI Configuration
Configurable options are
Configurable options are
• iSCSI
Alias
• iSCSI
Port
Number
• iSNSLoginControl
• iSNSServer
• SpeedWrite
• iSNSServer
• SpeedWrite
on each parameter.
Auto Target Management
ExpressNAV is the preferred interface for setting
up targets. On this page you can map devices
automatically to the default target or map each
device to its own target. By default, Access
Control and CHAP are disabled.
Refer to
Auto Target Management
ExpressNAV is the preferred interface for setting
up targets. On this page you can map devices
automatically to the default target or map each
device to its own target. By default, Access
Control and CHAP are disabled.
Refer to
on page 11, and
Mapping commands
on page 53 for details.