ATTO Technology 2700C Benutzerhandbuch

22

Installation: ExpressNAV

Manual Target Management: iSCSI Target 
Management
ExpressNAV is the preferred interface for setting 
up targets and access to targets. This page allows 
you to set up and configure iSCSI targets 
individually for Access Control, Device Maps and 
iSCSI CHAP. 
For the default target, Access Control and CHAP 
are disabled by default. For all manually-created 
targets, Access Control is enabled and CHAP is 
disabled by default.
Refer to 

 on page 11, and 

Mapping commands

 on page 53 for details. 

Bridge Configuration
You must enter the current Admin password to 
change usernames or passwords. Other 
configurable options are

•  Minimum Operating Temperature 
•  Maximum Operating Temperature 
•  Operating Temperature Warning
• Enable/disable 

Identify 

Bridge

• Bridge 

Name

• Restore 

Defaults

Refer to 

 on page 41 for 

details on each parameter.
Firmware Update
Use ExpressNAV to update firmware. For details, 
refer to 

Advanced CLI Configuration
Allows you to input any CLI command available 
through the iPBridge. 

To use the Advanced Configuration page
1

Type in the CLI command

2

Click the 

Submit button: this is equivalent to 

typing in the CLI command into a TCP/IP or 
serial port CLI session. 
A text field beneath the box will list the most 
recent commands issued to the iPBridge 
through this page.

If you enter an incorrect parameter, the CLI 
help text will be displayed, showing the 
parameters available.

3

If your entry was correct, type 
saveconfiguration

4

Click the 

Submit button. Your changes will be 

implemented.

Restart Firmware 
Implements a firmware restart of the bridge and 
makes permanent any changes you have made 
since the last firmware restart.

Note

1

Click the

 Restart button. 

A box will tell you to wait until the counter gets 
to 0 and then the browser will refresh. 

2

If the browser does not refresh after the counter 
gets to 0, click the link to refresh it manually. 

Help 
Gives help information about the command line 
interface commands and troubleshooting tips via 
links to pages with help text for each category of 
options and one link to the Troubleshooting Tips 
and FAQs page on the ATTO website, 

www.attotech.com.

 

Contact information for ATTO technical support 
is on the right.
Help is always available by pressing any word 
shown in red on the screen.