ATTO Technology 2700C Benutzerhandbuch
52
Interfaces: CLI
iSCSIWANIPAddress
Sets the IP address reported from the sendtargets
command. Setting the address to 0.0.0.0 will cause the
unit to report the LAN IP address.
Sets the IP address reported from the sendtargets
command. Setting the address to 0.0.0.0 will cause the
unit to report the LAN IP address.
Set syntax: set iSCSIWANIPAddress [dp[n] | all]
[xxx.xxx.xxx.xxx]
Get syntax: get iSCSIWANIPAddress [dp[n] | all]
[xxx.xxx.xxx.xxx]
Get syntax: get iSCSIWANIPAddress [dp[n] | all]
iSNSLoginControl
Specifies whether the iPBridge will delegate its access
control/authorization to an iSNS server.
Note: iSNSLoginControl cannot be used with
AccessControl
Specifies whether the iPBridge will delegate its access
control/authorization to an iSNS server.
Note: iSNSLoginControl cannot be used with
AccessControl
Default: disabled
Set syntax: set iSNSLoginControl [enabled | disabled]
Requires a SaveConfiguration command
Get syntax: get iSNSLoginControl
Set syntax: set iSNSLoginControl [enabled | disabled]
Requires a SaveConfiguration command
Get syntax: get iSNSLoginControl
iSNSServer
Specifies whether the IP address of a valid iSNS server
from which the iPBridge will attempt iSCSI initiator
discovery. Setting to 0.0.0.0 will disable iSNS server
lookup.
Specifies whether the IP address of a valid iSNS server
from which the iPBridge will attempt iSCSI initiator
discovery. Setting to 0.0.0.0 will disable iSNS server
lookup.
Default: 0.0.0.0
Set syntax: set iSNSServer [xxx.xxx.xxx.xxx]
Requires a SaveConfiguration command
Get syntax: get iSNSServer
Set syntax: set iSNSServer [xxx.xxx.xxx.xxx]
Requires a SaveConfiguration command
Get syntax: get iSNSServer