Bunn SRUA Benutzerhandbuch
Page 24
START SWITCH (BREW)
FIG. 20 START SWITCH (BREW)
Location:
The brew start switch is located on the lower right
of the front access panel, beneath the selector switch.
Test Procedures:
1. Disconnect the brewer from the power source.
2. Remove the wires from the start switch terminals.
3. Check for continuity across the switch terminals
1. Disconnect the brewer from the power source.
2. Remove the wires from the start switch terminals.
3. Check for continuity across the switch terminals
when the switch is held in the lower position.
Continuity must not be present when the switch is
in the upper position.
Continuity must not be present when the switch is
in the upper position.
If continuity is present as described, reconnect the
wires the switch is operating properly.
wires the switch is operating properly.
If continuity is not present as described, replace the
switch.
switch.
BLU to Brew Timer
RED from ON/OFF
Switch
Switch
FIG.21 BREW START SWITCH TERMINALS
P2119.65
SERVICE (cont.)
Removal and Replacement:
1. Remove the wires from the switch terminals.
2. Compress the clips on the back side of the switch
1. Remove the wires from the switch terminals.
2. Compress the clips on the back side of the switch
and gently push them through the opening.
3. Push the new switch into the opening and spread
the clips to hold switch.
4. Refer to Fig. 21 and reconnect the wires.
P2130.25
DISC
ON
NE
CT FR
OM PO
WE
R SO
UR
CE
BE
FO
RE
RE
MO
VAL
OF
ANY
PAN
EL
O
R
RE
PLA
CE
MEN
T OF
AN
Y C
OM
PON
EN
T!
W
AR
NI
NG
!
DISC
ON
NEC
T FR
OM
PO
WE
R S
OU
RC
E
BEF
OR
E RE
MO
VA
L O
F AN
Y P
AN
EL O
R
REP
LAC
EM
EN
T O
F A
NY
COM
PON
EN
T!
W
AR
NIN
G
!
AT
TE
NT
IO
N:
T
UR
N
OF
F
W
HE
N
UN
AT
TE
ND
ED
10067.3 070102