Bunn SRUA Benutzerhandbuch

Page 25

FIG. 22 SWING ARM SWITCH

P2139.40

Location:

The swing arm switch is attached to the cupola

cover.

Test Procedures:
1. Disconnect the brewer from the power source.
2. Remove the cupola cover end caps, swing spout

and cupola cover.

3. Disconnect the two black wires connected to the

switch.

4. Check for continuity across the terminals on the

switch.

5. Continuity should be present when switch plunger

is depressed.

If continuity is present as described, the switch is
operating properly.
If continuity is not present as described, replace the
switch.

FIG. 23 SWING ARM SWITCH TERMINALS

Removal and Replacement:
NOTE:  Measure the distance from the top of the switch

plunger to the hood cover. The same distance is
needed when the new switch is installed.

1. Remove nut securing switch to hood cover and

remove switch.

2. Install new switch. Refer to Fig. 23 and reconnect

the wires.

3. Install all panels.
4. Test action of swing arm and switch for activation.
5. Adjust switch assembly up or down as needed for

proper operation.

NOTE:  Do not remove cam assembly from swing

spout.

BLK from Pump

BLK from Timer

P2140.70

10067.3 070102