Epson RX600 Produktdatenblatt

Epson Stylus Photo RX600

16 -

 Epson Stylus Photo RX600

2/04

3. Open the ink cartridge cover holder by pulling the back up 

and toward you.

Caution: 
Never attempt to open the cartridge holder’s cover while the 
print head is moving. Wait until the cartridges have moved to the 
replacement position.

4. Identify the cartridge you need to replace. Press in the tab at 

the back of the cartridge to release it, then lift the cartridge 
straight out. Dispose of it carefully.

Note:
The illustration above shows the black cartridge being removed. 
Only remove the cartridge(s) you need to replace.

5. Unwrap the new cartridge.

6. Insert the new cartridge into the holder. Press down firmly 

until it clicks into place.

If you need to replace other ink cartridges, repeat steps 4 
through 6 before continuing with step 7.

7. Close the cartridge cover, then lower the scanner unit.

Caution: 
If you find it difficult to close the cover, make sure all the 
cartridges are firmly seated. Press down on each newly installed 
cartridge until you hear it click into place. Do not attempt to force 
the cover closed.

The RX600 begins charging the ink delivery system and the 
message 

Ink Charging

 appears on the LCD screen. When 

you see the message 

Ink cartridge replacement

 

completed

, click 

OK

. 

Caution: 
Never turn off the RX600 while Ink Charging appears on the 
LCD screen, unless the RX600 hasn’t moved or made noise for 
more than 5 minutes. This may cause incomplete charging of ink.

If your printouts look grainy or vertical lines appear jagged, 
you may need to align the print head. 

1. Make sure the RX600 is turned on and not printing, and 

the 

!

error light is off.

2. Load several sheets of plain letter-size paper.

3. Press the 

Setup

 button to enter setup mode, then press the 

u

 and d buttons to select 

Head Alignment

.

4. Press the 

OK

 button, then press 

OK

 again to print an 

alignment pattern.

Open the cover 
from the back