Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Ratgeber Für Administratoren

Seite von 542
  Chapter 2.  VLANs
 
   
|
     
19
ProSafe Managed Switch 
Assign Ports to VLAN2
This sequence shows how to assign ports to VLAN2, and to specify that frames will always 
be transmitted tagged from all member ports and that untagged frames will be rejected on 
receipt.
CLI: Assign Ports to VLAN2
Web Interface: Assign Ports to VLAN2
1. 
Assign ports to VLAN2.
a. Select Switching > VLAN > Advanced > VLAN Membership. A screen similar to 
the following displays.
b.  In the VLAN ID list, select 2
c.  Click Unit 1. The ports display.
d.  Click the gray boxes under ports 1 and 2 until T displays. The T specifies that the 
egress packet is tagged for the ports.
e.  Click Apply to save the settings.
2. 
Specify that only tagged frames will be accepted on ports 1/0/1 and 1/0/2.
(Netgear Switch) #config
(Netgear Switch) (Config)#interface range 1/0/1-1/0/2
(Netgear Switch) (conf-if-range-1/0/1-1/0/2)#vlan participation include 2
(Netgear Switch) (conf-if-range-1/0/1-1/0/2)#vlan acceptframe vlanonly
(Netgear Switch) (conf-if-range-1/0/1-1/0/2)#vlan pvid 2
(Netgear Switch) (conf-if-range-1/0/1-1/0/2)#exit
(Netgear Switch) (Config)#vlan port tagging all 2
(Netgear Switch) (Config)#