Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Softwarehandbuch

This command returns the status of the specified port.

Power management commands are supported on the M6100 series 
switches only.

This command enables chassis automatically re-adjusts power allocation to the blades such 
that lowest priority port on the chassis gets automatically shut down and higher priority ports 
on the chassis are powered.

This command disables auto power rebalance among blades in the chassis. 

Format

cablestatus unit/slot/port

Mode

Privileged EXEC

Cable Status

One of the following statuses is returned:

Normal

. The cable is working correctly.

Open

. The cable is disconnected or there is a faulty connector.

Short

. There is an electrical short in the cable.

Cable Test Failed

. The cable status could not be determined. The cable may in fact be 

working.

Cable Length

If this feature is supported by the PHY for the current link speed, the cable length is displayed as a 
range between the shortest estimated length and the longest estimated length. Note that if the link is 
down and a cable is attached to a 10/100 Ethernet adapter, then the cable status may display as 
Open or Short because some Ethernet adapters leave unused wire pairs unterminated or grounded. 
Unknown is displayed if the cable length could not be determined.

Default

disabled

Format

power auto-rebalance

Mode

Chassis Global Config

Format

no power auto-rebalance

Mode

Chassis Global Config