Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Softwarehandbuch

This section describes the commands you use to configure Generic Attribute Registration 
Protocol (GARP) and view GARP status. The commands in this section affect both GARP 
VLAN Registration Protocol (GVRP) and GARP Multicast Registration Protocol (GMRP). 
GARP is a protocol that allows client stations to register with the switch for membership in 
VLANS (by using GVMP) or multicast groups (by using GVMP).

This command sets the GVRP join time per GARP for one interface, a range of interfaces, or 
all interfaces. Join time is the interval between the transmission of GARP Protocol Data Units 
(PDUs) registering (or reregistering) membership for a VLAN or multicast group. This 
command has an effect only when GVRP is enabled. The time is from 10 to 100 
centiseconds. The value 20 centiseconds is 0.2 seconds.

This command sets the GVRP join time to the default and only has an effect when GVRP is 
enabled.

Interface

A valid slot and port number separated by forward slashes.

Port VLANID

The VLAN ID that is associated with the port.

Private Group ID The identifier of the private group (from 1 to 192).

Private Group 
Name

The name of the private group. The name string can be up to 24 bytes of non-blank characters.

Private Group 
Mode

The mode of the private group. The mode can be either isolated or community.

Default

20

Format

set garp timer join centiseconds

Mode

Interface Config

Global Config

Format

no set garp timer join

Mode

Interface Config

Global Config