Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Ratgeber Für Administratoren

You can then activate RIP or OSPF, used by routers to exchange route information, on top of 
IP Routing. RIP is more often used in smaller networks, while OSPF was designed for larger 
and more complex topologies.

The following figure shows a Layer 3 switch configured for port routing. It connects three 
different subnets, each connected to a different port. 

Subnet 2

Subnet 3

Subnet 5

Port 1/0/3
192.130.3.1

Port 1/0/5
192.64.4.1

Port 1/0/2
192.150.2.2

Layer 3 switch
acting as a router

The example is shown as CLI commands and as a web interface procedure.

The following script shows the commands that you use to configure the managed switch to 
provide the port routing support shown in 

104.

Use the following command to enable routing for the switch. Execution of the command 
enables IP forwarding by default.

(Netgear Switch) #config

(Netgear Switch) (Config)#ip routing 

(Netgear Switch) (Config)#exit