Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Ratgeber Für Administratoren

You can add, remove, or replace a chassis member.

Preconfigure the new member, if desired.

Remove the blank front panel from the chassis slot.

Slide the blade slightly into the open slot.

Keep the injector/ejector handles in the open position as you slide the blade into the chassis 
slot.

Use both hands to push both handles toward the center of the blade.

Finger tighten or use a screwdriver to turn the front pane screws on each injector/ejector 
handle clockwise and completely down.

Verify, by monitoring the supervisor console port, that the new blade joins the chassis by 
issuing the show chassis command. The new blade should join as a member (never as 
supervisor; the existing supervisor of the chassis should not change).

If the firmware version of the newly added member is not the same as the existing 
supervisor, update the firmware as described in 

Finger loosen or use a screwdriver to turn the screws on each injector/ejector handle 
counterclockwise and completely up.

Use both hands to pull up both handles from the center of the blade.

Pull out the blade slightly and then completely out.

Install the blank front panel to the open slot.

To remove the member from the chassis configuration, issue the no member <unit-id> 
command.

Finger loosen or use a screwdriver to turn the screws on each injector/ejector handle 
counterclockwise and completely up.

Use both hands to pull up both handles from the center of the blade.

Pull out the blade slightly and then completely out.

If you will be installing a blade that is a different model, remove the blade from the 
configuration by issuing the no member <unit-id> command.

Install the new blade in the chassis.

You can put it either in the same position as the previous blade or in another open slot.

If you are installing a blade that is the same model, put it in the same position in the chassis 
as the one that you just removed.