Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Softwarehandbuch

The range is 4 to 30 seconds. The default value is 15 seconds. This interval is a time for 
listening and learning states before transitioning a port to the forwarding state.

Use the Max Age field to configure the spanning tree maximum age time for a specified 

VLAN. 

Max age is the maximum age time before a bridge port saves its configuration 
information. The range is 6 to 40 seconds. The default value is 20 seconds.

Configure the bridge Priority of a VLAN. 

The allowed values are between 0 and 61440. The valid values are listed in the following 
table. 

The default value is 32768. If the value configured is not among the specified values, 
then it is rounded off to the nearest valid value.

Click the Add button.

PVST/RPVST is enabled for the selected VLAN.

To disable PVST/RPVST for the specified VLAN entry, click the Delete button.

Click the Apply button.

The updated configuration is sent to the switch. Configuration changes take effect 
immediately.

You can view and configure Per VLAN Spanning Tree Protocol (PVST)/Per VLAN Rapid 
Spanning Tree Protocol (RPVST) Interface settings for the device.



Prepare your computer with a static IP address in the 169.254.100.0 subnet, for 

example, 169.254.100.201.

Connect an Ethernet cable from an Ethernet port on your computer to an Ethernet port on 

the switch.

Launch a web browser.

Enter the IP address of the switch in the web browser address field.

The default IP address of the switch is 169.254.100.100. 

0

4096

8192

12288

16384

20480

24576

28672

32768 (default)

36864

40960

45056

49152

53248

57344

61440

–

–