Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Softwarehandbuch

The Per VLAN Cost is the path cost from the port to the root bridge. 

The values allowed are between 1 and 200,000,000. By default, cost is not configured. 
Use the value 0 to unconfigure the setting. If per VLAN cost is not configured, the path 
cost value is set based on Link Speed.

Click the Apply button.

The updated configuration is sent to the switch. Configuration changes take effect 
immediately.

The following table describes the nonconfigurable data that the 

PVST/RPVST Interface 

Configuration screen displays.

You can view and configure Per VLAN Spanning Tree Protocol (PVST)/Per VLAN Rapid 
Spanning Tree Protocol (RPVST) Statistics settings for the device.



Prepare your computer with a static IP address in the 169.254.100.0 subnet, for 

example, 169.254.100.201.

Connect an Ethernet cable from an Ethernet port on your computer to an Ethernet port on 

the switch.

Launch a web browser.

Enter the IP address of the switch in the web browser address field.

The default IP address of the switch is 169.254.100.100. 

144

160

176

192

208

224

240

–

–

Interface

The list of physical interfaces and LAGs.

Role

Indicates the role of the interface. Possible values are as follows: 
Disabled, Root, Designated, Alternate, Backup, and Master.

The blank field is displayed for the interface which is 

not included for the specified VLAN.

Status

Indicates the status of the interface. Possible values are as follows: 
Discarding, Learning, Forwarding, and Disabled.

The blank field is displayed for the interface which is 

not included for the specified VLAN.