Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Softwarehandbuch
Configure System Information
27
M6100, M5300, and M7100 Series Managed Switches
When Auto Config is selected, the appropriate IPv6 prefix and prefix length is displayed in
this field.
this field.
17.
In the IPv6 Gateway field, specify the default IPv6 gateway for the management VLAN
interface.
18.
Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
immediately.
Configure the Initial Service Port Settings
To do the initial service port configuration:
1.
Prepare your computer with a static IP address in the 169.254.100.0 subnet, for
example, 169.254.100.201.
2.
Connect an Ethernet cable from an Ethernet port on your computer to an Ethernet port on
the switch.
3.
Launch a web browser.
4.
Enter the IP address of the switch in the web browser address field.
The default IP address of the switch is 169.254.100.100.
The Login screen displays.
5.
Enter the user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
do not enter a password.
6.
Click the Login button.
The web management interface menu displays.
7.
Click System > Management > Initial Setup.
The Initial Setup screen displays.
8.
Scroll down to the bottom of the screen to display the Service Port Configuration section.
9.
Select an IPv4 Address Assignment radio button.
This specifies the method for getting IPv4 network parameters (IPv4 address and
network mask) for the service port. Possible options are DHCP, BootP, or Static. The
default value is Static.
network mask) for the service port. Possible options are DHCP, BootP, or Static. The
default value is Static.
10.
Specify the IP Address for the service port.