Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Softwarehandbuch
Configure Switching Information
300
M6100, M5300, and M7100 Series Managed Switches
8.
Select Switching > MLAG > Basic > VPC Global Configuration.
The VPC Global Configuration screen displays.
9.
Scroll down to the Peer Link section.
10.
Select the Enable Modification option to enable port-channel modification.
11.
Use the Port Channel list to configure a LAG interface as the VPC peer link and
enable/disable the peer link protocol.
The peer link protocol is disabled by default. Select None to remove the lag from a port
channel. The port channel cannot be changed or reset when the operational VPC mode is
Enabled.
channel. The port channel cannot be changed or reset when the operational VPC mode is
Enabled.
12.
Click the Apply button.
The switch is updated with the values you entered. Configuration changes take effect
immediately.
immediately.
The following table describes the nonconfigurable Peer Link fields.
Configure the Peer Detection Settings
The peer detection feature uses the Dual Control Plane Detection Protocol (DCPDP), a
UDP-based protocol, to detect peer links. You must configure peer detection on an IP
interface with a VLAN that is not shared by any of the VPC interfaces.
UDP-based protocol, to detect peer links. You must configure peer detection on an IP
interface with a VLAN that is not shared by any of the VPC interfaces.
Table 113. Peer Link
Field
Description
Peer Link Status
The operational status of the peer link, which is either Up or Down.
Peer Keepalive Priority
The peer keep-alive priority.
Peer Link STP Mode
The Spanning Tee Protocol (STP) administrative mode of the port
channel. When enabled, the port channel participates in the STP
operation to help prevent network loops.
channel. When enabled, the port channel participates in the STP
operation to help prevent network loops.