Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Softwarehandbuch

Specify the VLAN ID to compare against an Ethernet frame. 

Valid range of values is 1 to 4093. Either a VLAN range or VLAN can be configured.

Click the Add button.

The rule is added to the ACL based on the Destination MAC.

To remove the currently selected rule from the ACL based on destination MAC address, 

click the Delete button.

Click the Apply button.

The updated configuration is sent to the switch. Configuration changes take effect 
immediately.

For information about the ACL Wizard, see 

To complete the destination MAC ACL using ACL wizard, you must do the following:

Select the destination MAC ACL as ACL type.

Enter the DMAC VLAN as the ACL Rule.

To select the direction and ports to bind the ACL, in the Directions field, select the packet 

filtering direction for an ACL. 

The options are Inbound or Outbound.

The Port Selection Table specifies the list of all available valid interfaces for ACL 
mapping. 

All non-routing physical interfaces and interfaces participating in LAG are listed.

A MAC ACL consists of a set of rules which are matched sequentially against a packet. When 

a packet meets the match criteria of a rule, the specified rule action (Permit/Deny) is taken, 
and the additional rules are not checked for a match. Rules for the MAC ACL are 
specified/created using the MAC ACL Rule Configuration screen.

There are multiple steps involved in defining a MAC ACL and applying it to the switch:

Create the ACL Name. 

Create rules for the ACL. 

Assign the ACL by its name to a port. 

Optionally, use the 

 screen to 

view the configurations.