Honeywell HE360 Installationsanleitung

13

69-2631ES—03



Humidifier is level.



Control wiring was reviewed using circuit diagram.



Humidifier is plugged in.



Feed line has no kinks.



Drain line slopes continuously down and ends at floor drain.



Water hose inside humidifier is connected to PerfectFlow™ water distribution tray.

After installation use the following steps to check the humidifier operation:

1. Turn on the power and the water supply.

2. Turn the H8908 Humidistat to On and turn on the heat by setting the thermostat 

to 10ºF (6ºC) above room temperature.

3. Make sure that water is flowing out of the drain hose. If water does not flow, see 

Troubleshooting Your Humidifier section.

4. Check for leaks.

5. Reset the thermostat and H8908 Humidistat to a comfortable setting for auto-

matic operation.

Your Honeywell humidifier uses the principle that vapor (evaporated water) is created 

when warm air blows over a water-soaked area. As the vapor circulates, the relative 

humidity rises.

Your humidity control monitors the relative humidity and activates the humidifier 

accordingly. The humidifier has a water supply that dispenses water evenly over a 

humidifier pad. The warm dry air, from the furnace, passes over the humidifier pad and 

picks up the moist air to circulate it throughout your home.

Humidified air feels warmer and more comfortable so you may be able to lower your 

thermostat heating setpoint, which saves money on your heating fuel bills. The end 

result is that your humidifier gives you a comfortable environment that is also energy 

efficient.