Honeywell HE360 Installationsanleitung

69-2631ES—03

16 

7. Disconnect the drain hose from the drain fitting on the bottom of the humidifier 

housing.

8. Clean the drain fitting, if necessary.

9. Bend the drain hose to loosen any mineral deposits.

10. Flush the drain hose with pressurized water (a running tap) to clean the hose.

11. Reattach the drain hose to the drain fitting.

12. Snap the water nozzle back on the tray.

13. Be sure the marked end of the pad is facing up. Place the tray on the new pad.

14. Place the humidifier pad assembly in the humidifier housing. Be sure the water 

feed tube is placed in the guide slots.

15. Replace the humidifier cover.

16. Verify the humidifier operation by following the steps in the Checking Your 

Humidifier for Correct Operation section.

After winter startup or servicing, use the following steps to check your humidifier 

operation:

1. Turn on the humidifier power and water supply.

2. Turn the humidistat to its highest setting and set the thermostat to 10°F (6°C) 

above the room temperature.

3. Observe that water is flowing out of the drain hose.

4. Reset the thermostat and humidistat to a comfortable setting for automatic oper-

ation.

M12809

COVER 
ASSEMBLY

HUMIDIFIER 
PAD ASSEMBLY

FEED TUBE NOZZLE

WATER 
DISTRIBUTION TRAY

HUMIDIFIER
HOUSING

THUMB 
SCREW